Zozeen craigslist
Get notified of Garage Sales near you
Call: +1-877-576-7249
Customer Care representatives are available daily
from 9 a.m. to 5 p.m. PT

Identifying plywood sizes and types

Home » Decoration Materials » Plywood panels »

To combat this, the dado should be cut at 23/32" to ensure a proper fit.

Other Wood SizingAre other types of wood affected by this interesting but inconsistent model of measurement?

3 quarter inch plywood

 

Ironically, yes.

Try finding a 2×4 that actually measures two inches by four inches. Instead, if you pull out a tape measure, you'll find that the 2×4 actually measures 1-1/2 inches by 3-1/2 inches in size. You'll find that a 2×6 is similarly one-half inch thinner and narrower than advertised. One-by material can be even more confusing, because the one-half inch rule only applies to one side. For instance, a 1×4 will actually measure 3/4-inch thick by 3-1/2 inches in size.

one inch plywood

 

While this rule applies to dimensional lumber, particularly the SPF stock that is prevalent in home centers but often used for home building, it doesn't apply to hardwoods and exotics sold by fine woodworking suppliers. These woods are instead sold by the board-foot, so the actual measurements of the length, width and thickness are used to calculate the cost of each individual board. As such, when buying hardwoods, you may end with two boards that are the exact same size in terms of board-feet, but the boards are obviously very different along the length, width or thickness.

half inch plywood

 

Why Isn't a 3/4-inch Sheet actually 3/4-Inches Thick?The question most commonly posed when people learn of the variations in wood sizes is, "why can't they just sell a two-inch thick by four-inch wide board when I buy a 2×4?"

There are two answers commonly given. The first is that manufacturers determined that if they shrunk the sizes of each piece slightly, they could get more pieces of sellable material out of each and every tree that they harvest. Over the economies of scale, 1/32-inch in each piece of plywood can add a considerable amount of extra income for the manufacturer.

A less cynical answer would be that the reduced sizes actually are adjusted for homebuilding purposes. For instance, a six-inch thick wall can be completed easily using a 5-1/2 inch wide wall stud and a 1/2-inch thick sheet of drywall applied on the face of the framed wall.











© 2015 | All Rights Reserved | www.zozeen.com